Intensity – PRG Vx76 User Manual 3.6 User Manual
Page 93
VX76 SOFTWARE USER MANUAL
77
Intensity
The keypad can be used to adjust the brightness of the luminaire’s beam. Intensity responds to a percentage value of
0-100.
The [At] button is used to enter intensity values:
+
<Chan> [n] [At] [m] [Enter] - changes the intensity level of the selected channel to m.
+
<Chan> [n] [Thru] [q] [At] [m] [Enter] - changes the intensity level for the selected range of channels to m.
The [Full] button is used to quickly set intensity to 100%.
+
<Chan> [n] [Full] [Enter] - changes the intensity level of the selected channel to 100%.
The [+] and [-] buttons can be used in combination with the [At] button to increment or decrement a current intensity
value by a specific amount. For example, if the current intensity value is 50%:
+
<Chan> [n] [At] [+] [0] [5] [Enter] - increases the intensity level of the selected channel to 55%.
+
<Chan> [n] [At] [-] [0] [5] [Enter] - decreases the intensity level of the selected channel to 45%.
To quickly enter an intensity below 91%, but divisible by 10, use only the first digit of the desired level (for
example, [At] [5] = 50%).
To Mark a channel on the command line, enter the following sequence:
+
[Chan] [n] [At] [At] [Enter]
Tip