TeeJet Swath XL SmartPad II - Manual (Page 111)

SmartPad II
Software Version 4.03
Chapter 3 - Real-Time Guidance 3-57
The Circle Pivot Guidance Mode
Marking Point B
Once point A is marked the operator should drive along the pivot circle until they feel they have described the circle
as well as possible. The Mark A button has changed to Mark B button, see Figure 3-78. The Swath software will not
allow the user to mark point B with in 12 seconds of marking point A. After 12 seconds, the Mark B button becomes
active and the operator can mark point B anytime after.
Circle Guideline Guidance
Once the operator has marked point B, the circle guideline will appear in the SmartPad display and the lightbar will
begin providing guidance instructions. It is not necessary to drive the entire circumference of the center pivot in order
to initiate guidance. As shown in this example, the operator drove only a portion of the circumference marking points
A and B, and then used the guideline to continue driving the remainder of the circle, see Figure 3-79.
Figure 3-77: Marking Point A
Figure 3-78: Preparing to Mark Point B