TeeJet Swath XL SmartPad II - Manual (Page 16)

1-8 Chapter 1 - Introduction
SmartPad II Installation Instructions
SmartPad II
Software Version 4.03
SmartPad II and Interface Cable
The SmartPad II and Interface cable should be located in the cab so that the operator can easily reach, view
and operate the system. See Figure 1-4 and Figure 1-5 for instruction on how to connect the Lightbar and
SmartPad II to the interface cable. Make sure the interface cables are not under any excess strain, can not be
closed in a cab door or window, or stepped on by the operator. We recommended that the interface box be
mounted within arms reach of the operator and out of harms way.
Figure 1-4: Connecting SmartPad II Swath XL / GuideLine Components
Figure 1-5: Connecting SmartPad II CenterLine Components