TeeJet Swath XL SmartPad II - Manual (Page 164)

4-28 Chapter 4 - Waypoint Navigation
Nav 2 Point Real-Time Scenarios
SmartPad II
Software Version 4.03
Once the setup process is complete and Nav 2 Point has been started, a file name dialog will appear prior to starting
the real-time process and displaying the view page. In this example, the only file name information required is the
boundary file name.
Once the boundary file is named the user will select GO and start the real-time process. Figure 4 -30 shows the real-
time view page. The left side shows the user preparing to start the boundary mapping process. The Map boundary
icon is highlighted and the keys is pressed. The map boundary icon changes and the user starts mapping the field
boundary (right side) notice that the antenna offset is shown with respect to the vehicle.
Figure 4 -31 shows the real-time icons that are included in the real-time view button bar area. This list of icons
changes based on how the setup process was configured.
Figure 4-29: Boundary File Name Dialog
Figure 4-30: Boundary Mapping in the Real-time View Page