TeeJet Swath XL SmartPad II - Manual (Page 191)

Fieldware for Smartpad II
Software Version 4.03
Chapter 5 - Field Mapping 5-13
About Mapper Real-Time Mapping
The Real-Time View Page
There is only one real-time page associated with the Mapper real-time process, see Figure 5-15. The left side of the
real-time page contains the map window. This is where the vehicle and any map data, points, boundary, lines, and
polygons can be viewed.
The right side of the view page contains several buttons located in the button bar, see Figure 5-15. A detailed descrip-
tion of each button is listed in Figure 5-14. The number of buttons located in the button bar will vary based on how
Mapper application is setup. For example, if you have selected to create the field boundary in the setup process, a
Map Field Boundary button will be included in the button bar. To navigate up and down in the button bar use the
keys located on the Smartpad. To select or activate a highlighted button in the button bar press the key on
the Smartpad.
The bottom of the view page contains the information window. Various information about the current real-time pro-
cess will be displayed in this window. There is a specific Information button located in the button bar, when this but-
ton is either highlighted or pressed, information such as point name will be displayed. If you have a field boundary
displayed in the map window, the area of the field boundary, in Acres or Hectares, will also be displayed in the infor-
mation window.
Located at the bottom right corner of the view page is the key code box. This box displays which Smartpad keys are
active based on the current view page and button bar state.