Nav 2 point real-time scenarios, Mapping a field boundary – TeeJet Swath XL SmartPad II User Manual
Page 163
SmartPad II
Software Version 4.03
Chapter 4 - Waypoint Navigation
4-27
Nav 2 Point Real-Time Scenarios
Nav 2 Point Real-Time Scenarios
The following sub-sections will describe various Nav 2 Point real-time process scenarios.
Mapping a Field Boundary
In this example the operator wants to map a field boundary. The Data Setup Boundary menu item is set to New, see
Figure 4 -27. The operator has also decided not to show any existing points or grid data, this is accomplished by set-
ting the Point/Grid File menu item to Off. This setting could be set to New or Show and the operator would still be
able to create a new field boundary.
The field boundary that will be mapped is bounded by a fence and therefore the user must set an antenna offset to
place the antenna position off to one side of the vehicle, Figure 4 -28.
Figure 4-27: Data Setup Menu Page Configured to Map a New Field Boundary
Figure 4-28: Antenna Offset for Mapping a Field Boundary