TeeJet Swath XL SmartPad II - Manual (Page 18)

1-10 Chapter 1 - Introduction
CompactFlash Card Instructions
SmartPad II
Software Version 4.03
CompactFlash Card Instructions
Inserting the CompactFlash Card
The following instructions describe the basic procedure for inserting the optional 128MB CompactFlash
Data card into the SmartPad II:
• With power off, locate the CompactFlash card socket on the top of the SmartPad II, see Figure 1-6.
• Insert the CompactFlash card into the CompactFlash card socket. Make sure that the CompactFlash card
logo is facing out. Slide the card along the guide slots until it makes contact with the SmartPad II expan-
sion socket.
• The card will slide freely until it reaches the pins on the SmartPad II’s expansion socket, at which point,
you will feel some resistance.
• At this point, you should feel the card settle onto the expansion socket pins. Only a slight amount of
force is required to seat the card into the socket.
• Once you are certain the card is properly aligned with the SmartPad II expansion socket, insert the card
slightly beyond the resistance point to ensure it is fully seated into the socket. DO NOT FORCE THE
CARD.
Figure 1-6: Inserting the CompactFlash Card
CompactFlash
Flash Data
Card Logo