Altera PHYLite - Manual (Page 61)

Date Version Changes
December,
2014
2014.12.30
• Updated the name of the IP core from Altera PHYLite for
Memory to Altera PHYLite for Parallel Interfaces.
• Updated the maximum clock frequency from 800 MHz to
1333.333 MHz.
• Clarified that to achieve timing closure at 800 MHz and
above, you must use dynamic reconfiguration to calibrate
the interface.
• Added
data_out_n
/
data_io_n
signals to the Output Path
Signals table.
• Added
data_in_n
/
data_io_n
signals to the Input Path
Signals table.
• Updated
data_out
/
data_io
and
data_in
/
data_io
signals in the Input Path Signals and Output Path Signals
tables.
• Updated Parameter Settings table to include Group <x>
Timing Settings information.
• Updated Timing section to include Input Strobe Setup
Delay Constrain and Input Strobe Hold Delay
Constrain parameters information.
August, 2014 2014.08.18 • Renamed the term megafunction to IP core.
• Added information about output path data alignment,
input path data alignment, OCT, I/O standards,
placement restrictions, timing, dynamic reconfiguration.
• Added the PHYLite_delay_calculations.xlsx file.
• Replaced ALTERA_PHYLite_nand_flash_example_
131a10.qar file with nand_flash_example_14.0a10.qar
file.
November,
2013
2013.11.29 Initial release.
ug_altera_phylite
2015.01.16
Document Revision History 61
Altera PHYLite for Parallel Interfaces IP Core User Guide Altera Corporation
Send Feedback