CIRCUTOR AR6 Series - Manual (Page 10)

AR6 portable network analyzer
Page 10 of 69 User Manual
Fig.2-2.- Window showing the configuration
 CORCO: Active measurement name
 Three-phase 4 wires 50 Hz (DEFAULT TEXT). Description of the measurement (by
default the unit indicates the type of circuit selected when creating the measurement,
indicating DEFAULT TEXT). Users may change the measurement description text.
 Voltage ratios 1/1 - 300: Transformers ratio for the voltage channel.
 Current ratios: 100 -1/1 : 0- 1/1 : 0 – 1/1: Transformers ratio for the different current
channels. The three blocks correspond to the phase clamps, the neutral clamp and the
earth leakage current clamp.
Phase clamps; 100-1/1 means: 100 is the nominal current of the connected phase
clamp; 1/1 indicates that the unit recognises the clamp and auto-configures the scale.
The user must manually configure the scale only in the case of multi-scale clamps or
primary /5 clamps.
Neutral clamp; 0-1/1 : 0 means there is no neutral clamp. If used, this block would
indicate the parameters of the neutral clamp. 1/1 indicates that the unit is self-configured
Earth leakage current clamp; 0-1/1 :0 means there is no earth current leakage clamp.
If used, this block would indicate the parameters of the neutral clamp. 1/1 indicates that
the unit is self-configured
 Recording period: 600 seconds: That is the configured log period.
 Next trip: Condition (pending): This indicates if the recording needs a certain trigger
condition (parameter threshold or time gap). If it is not configured, the unit will display
"disabled"
2.2.5 Date and time
This displays the date and time at when the unit was configured.
2.2.6 Power button (On/Off)
To switch the analyzer ON or OFF, the user must press the ON/OFF button and confirm the
action on the menu that appears on the screen.
The button will light up either red or green in colour. The colour green indicates the unit is ON
and, if flashing, that it is in energy saving mode, with the screen off. Intermittent red indicates
that it is connected to the network and that the battery is charging, and the LED OFF means
that the analyzer is switched OFF.
2.2.7 REC/STOP Button (Log Control)
Once the user has configured and connected the unit, its correct connection must be verified by
checking the values displayed by the unit. If the connection is verified as correct, the user may
begin recording data by pressing this button. Likewise, in case that the user wishes to interrupt
an on going recording , this button must be pressed.
2.2.8 Validation (ENTER) button
This is used to run the function selected among the various options from the configuration and
display screens, or from the dynamic drop-down menu. It is referred to in this manual with the
λ
sign.