AGI Security SYS-HC0851S2 - Manual (Page 56)

47
cable. connect the HDD and the SATA
port
Close the chassis and fix the
screws to secure firmly.
3.3.3 2U series
This series DVR max supports 8 SATA HDDs. Please use HDD of 7200rpm or higher.
①Loosen the screws of the upper cover
and side pane
②
Remove the HDD upper bracket
③
Now you can see the bottom
bracket
④
Line up the HDD to the four holes of
the HDD bracket.
⑤
Fix the HDD firmly.
⑥
Install the upper bracket and
then Use screws to fix HDD in the
bracket.
⑦
Put the co ver in accordance with the
clip and then place the upper cover
back.
⑧
Secure the screws in the rear panel
and the side panel.
Important:
If the HDD amount is less than four, you do not need to install the HDD bracket.
When there is a bracket, please make sure the installation direction of HDDs is the same.
3.3.4 Rack Installation
1. Loosen the screws of the
upper cover.