HTC 10 Sprint - Manual (Page 161)

Connectivity 148
Important: For you to listen to music with your headset, the headset must support the A2DP Bluetooth
profile.
Note: Before you connect your headset, make it discoverable so your phone can find it. Refer to your
headset manual for details.
1. Swipe down from the status bar and tap > Bluetooth.
2. When you see the name of your headset in the Available Devices section, tap the name.
 Your phone pairs with the headset and the headset connection status is displayed in the Paired
Devices section.
Note: If automatic pairing fails, enter the passcode supplied with your headset.
The pairing and connection status is displayed below the hands-free headset or car kit name in the
Bluetooth phones section. When the Bluetooth headset or car kit is connected to your phone, the
Bluetooth connected icon is displayed in the status bar.
Reconnect a Headset or Car Kit
Normally, you can easily reconnect your headset by switching on Bluetooth on your phone, and then
turning on the headset. However, you might have to connect manually if your headset has been used with
another Bluetooth device.
Important: Make sure that the headset is discoverable. Refer to the headset manual for details.
1. Swipe down from the status bar and tap > Bluetooth.
2. Tap the headset ’s name in the Paired Devices section.
3. If prompted to enter a passcode, try 0000 or 1234, or consult the headset/car kit documentation
to find the passcode.
If you still cannot reconnect to the headset or car kit, follow the instructions in Disconnect From a
Bluetooth Device , and then follow the steps in Connect a Bluetooth Headset or Car Kit .
Disconnect From a Bluetooth Device
If you do not need to use Bluetooth at any given point, you can disconnect and unpair your phone from a
Bluetooth device.
1. Swipe down from the status bar and tap > Bluetooth.
2. In the Paired Devices section, tap next to the device to unpair.
3. Tap Unpair.
Note: Tap the name of the device to reconnect it.