Marantz AV8003 User Manual
Page 7
ENGLISH
4
OPERATION OF REMOTE CONTROLLER
REMOTE CONTROL
Operate the remote controller within a distance
of approx. 16.4 ft. (5m) from the infrared receptor
window on the front of the unit.
Remote controller
60°
Appro
x. 16.4 ft.
(5 m)
Caution:
• Do not allow direct sunlight, an inverter fl uorescent
light or other strong source of light to shine onto
the unit’s infrared receptor window. Otherwise,
the operation of the remote controller may be
disabled.
• Bear in mind that operating the remote controller
may cause other devices operated by infrared rays
to be operated by mistake.
• The remote controller cannot be operated if
the space between the controller and the unit’s
infrared receptor window is obstructed.
• Do not place any objects on top of the remote
controller.
Doing so may cause one or more buttons to be
held down which will cause the batteries to run
down.
LOADING BATTERIES
Before using the remote controller for the fi rst time,
load the batteries in the remote controller. The
batteries provided are used to verify the operations
of the remote controller only.
<RC2001>
1.
Remove the back cover.
2.
Insert the new alkaline batteries (AAA type)
with correct
ª
and
·
polarity.
3.
Close the battery cover until it clicks shut.
Notes:
• Under normal usage, alkaline batteries last
approximately 3 months.
The battery life varies depending on the frequency
of use and the remote controller settings. Frequent
use will wear down the batteries quicker.
Rechargeable batteries can also be used. In this
case, be sure to use only AAA type NiMH (Nickel
Metal Hydride) rechargeable batteries. When
using rechargeable batteries, be sure to follow
manufacturer guidelines for safety and proper
usage.
• When the batteries are almost worn out, “LOW” is
displayed on the LCD battery indicator.
• The settings remain saved in the remote controller
even if the power completely runs out. However,
the time setting will be lost, and so please set the
time setting again.
<RC101>
1.
Remove the battery cover.
2.
Insert the new batteries (AAA type) with correct
ª
and
·
polarity.
3.
Close the battery cover until it clicks shut.
Note:
• The life of the batteries used with the remote
controller is about 4 months with normal use.
CAUTIONS ON BATTERIES
• Use “AAA” type batteries in this remote controller.
• We recommend that you use alkali batteries.
• If the remote controller does not operate from
close to the unit, replace the batteries with new
ones, even if less then a year has passed.
• The included battery is only for verifying operation.
Replace it with a new battery as soon as possible.
• When inserting the batteries, be careful to do so in
the proper direction, following the + and - marks in
the remote controller’s battery compartment.
• To prevent damage or battery fl uid leakage:
- Do not use a new battery with an old one.
- Do not use two different types of batteries.
- Do not short-circuit, disassemble, heat or
dispose of batteries in fl ames.
• Remove the batteries when not planning to use the
remote controller for a long period of time.
• If the batteries should leak, carefully wipe off the
fl uid from the inside of the battery compartment,
then insert new batteries.
• When disposing of used batteries, please comply
with governmental regulations or environmental
public instruction’s rules that apply in your country
or area.
AV8003_U_Eng.indb 4
AV8003_U_Eng.indb 4
08.4.28 10:40:04 AM
08.4.28 10:40:04 AM