Marantz AV8003 - Manual (Page 91)

CONNECTIONS
SETUP
BASIC
OPERA
TION
ADV
ANCED
OPERA
TION
TROUBLESHOOTING
OTHERS
NAMES AND
FUNCTION
REMOTE
CONTROLLER
88
ENGLISH
MEM CLEAR (Initialization setting)
This returns the settings made in the RC2001 to their
initial settings.
1. Press the button next to the “MEM CLEAR”
indicator in the SYS.SETUP menu screen
in the LCD to display the initialization setting
screen.
2. Press the button next to the “NO” (Disable) or
“YES” (Enable) indicators on the LCD to either
enable or disable initialization.
3. Pressing the NO button automatically returns
the LCD to the SYS.SETUP menu.
P r e s s i n g t h e Y E S b u t t o n d i s p l a y s
“COMPLETED” on the LCD and completes
initialization.
The setting items that are initialized are shown
below.
• TIMER SETUP
• BACK LIGHT TIMER
• LCD
• BEEP
Note:
The LEARNING and CLOCK settings are not
initialized.
• Either press the ENTER button or wait three
seconds for the LCD to automatically return
to the SYS.SETUP menu.
• Pressing the Home button returns the LCD
to the MAIN MENU.
4. STATUS INDICATOR
This displays the settings made in the MAIN MENU
and the status of the remote device.
Checking the status
1. Display the MAIN MENU on the LCD of the
RC2001, then press the button next to the
“STATUS” indicator.
2. Pressing the ENTER button cycles through the
statuses of each of the items below.
• Remaining learning memory
• Remaining macro steps
• LCD timer setting
• Backlight timer setting
• Beep setting
• Firmware version
• Current clock time
Either press the ENTER button or wait three
seconds so that the LCD returns to the MAIN
MENU.
5. RESET
If the RC2001 is not operating properly, use the
procedure below to perform a reset (restart).
Performing a reset does not erase the settings in
the RC2001.
1. Remove the battery case cover.
2. Use a paper clip or other object to press the
reset button in the reset hole as shown in the
fi gure below to reset the RC2001.
Note:
Perform the reset with the battery pack loaded.
6. PROGRAMMABLE CODES
Number of Programmable Codes
This remote control has Flash memory 4M bit
(512KB) that enables it to program remote control
signals include the learned codes for up to 8000
codes.
This number is for Marantz remote control codes.
The actual number of codes may be less than 8000
depending on the type of the programmed remote
control signals.
Programmable Codes
This remote control may be unable to learn the
codes for some AV equipment due to the code types,
system, or other differences.
AV8003_U_Eng.indb 88 AV8003_U_Eng.indb 88 08.4.28 10:40:44 AM 08.4.28 10:40:44 AM