H3C Technologies H3C S10500 Series Switches - Manual (Page 168)

157
• The MAC address of IP phone B is 0011-2200-0001. The phone connects to a downstream device
named PC B whose MAC address is 0022-2200-0002 and to GigabitEthernet 1/0/2 on Device A.
• Device A uses voice VLAN 2 to transmit voice packets for IP phone A and uses voice VLAN 3 to
transmit voice packets for IP phone B.
• Configure GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 to work in automatic voice VLAN
assignment mode. In addition, if one of them has not received any voice packet in 30 minutes, the
port is removed from the corresponding voice VLAN automatically.
Figure 49 Network diagram for automatic voice VLAN assignment mode configuration
Configuration procedure
# Create VLAN 2 and VLAN 3.
<DeviceA> system-view
[DeviceA] vlan 2 to 3
Please wait... Done.
# Set the voice VLAN aging time to 30 minutes.
[DeviceA] voice vlan aging 30
# Since GigabitEthernet 1/0/1 might receive both voice traffic and data traffic at the same time, to
ensure the quality of voice packets and effective bandwidth use, configure voice VLANs to work in
security mode. Configure the voice VLANs to transmit only voice packets. By default, voice VLANs work
in security mode. (Optional)
[DeviceA] voice vlan security enable
# Configure the allowed OUI addresses as MAC addresses prefixed by 0011-1100-0000 or
0011-2200-0000. In this way, Device A identifies packets whose MAC addresses match any of the
configured OUI addresses as voice packets.
[DeviceA] voice vlan mac-address 0011-1100-0001 mask ffff-ff00-0000 description IP phone
A
[DeviceA] voice vlan mac-address 0011-2200-0001 mask ffff-ff00-0000 description IP phone
B
# Configure GigabitEthernet 1/0/1 as a hybrid port.
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] port link-type hybrid
# Configure GigabitEthernet 1/0/1 to operate in automatic voice VLAN assignment mode. By default,
a port operates in automatic voice VLAN assignment mode. (Optional)