H3C Technologies H3C S10500 Series Switches User Manual
Page 201
190
[PE1] traffic behavior T200
[PE1-behavior-T200] remark customer-vlan-id 40
[PE1-behavior-T200] quit
# Create a QoS policy named sqinq, associate traffic class A100 with traffic behavior T100, and
associate traffic class A200 with traffic behavior T200.
[PE1] qos policy sqinq
[PE1-qospolicy-sqinq] classifier A100 behavior T100
[PE1-qospolicy-sqinq] classifier A200 behavior T200
[PE1-qospolicy-sqinq] quit
# Apply QoS policy sqinq to the outgoing traffic on the port.
[PE1-GigabitEthernet1/0/2] qos apply policy sqinq outbound
# Set the TPID value in the outer tag to 0x8200.
[PE1-GigabitEthernet1/0/2] qinq ethernet-type service-tag 8200
[PE1-GigabitEthernet1/0/2] quit
2.
Configure PE 2.
•
Configure GigabitEthernet 1/0/1.
# Configure GigabitEthernet 1/0/1 as a hybrid port to permit frames of VLAN 100 and VLAN 200 to
pass through untagged.
[PE2] interface gigabitethernet 1/0/1
[PE2-GigabitEthernet1/0/1] port link-type hybrid
[PE2-GigabitEthernet1/0/1] port hybrid vlan 100 200 untagged
[PE2-GigabitEthernet1/0/1] quit
# Create class A30 and configure the class to match frames with CVLAN 30.
[PE2] traffic classifier A30
[PE2-classifier-A30] if-match customer-vlan-id 30
[PE2-classifier-A30] quit
# Create traffic behavior P100 and add the action of inserting outer VLAN tag 100.
[PE2] traffic behavior P100
[PE2-behavior-P100] nest top-most vlan-id 100
[PE2-behavior-P100] quit
# Create class A40 and configure the class to match frames with CVLAN 40. Create traffic behavior
P200 and add the action of inserting outer VLAN tag 200.
[PE2] traffic classifier A40
[PE2-classifier-A40] if-match customer-vlan-id 40
[PE2-classifier-A40] quit
[PE2] traffic behavior P200
[PE2-behavior-P200] nest top-most vlan-id 200
[PE2-behavior-P200] quit
# Create a QoS policy named qinq, associate traffic class A30 with traffic behavior P100, and associate
traffic class A40 with traffic behavior P200.
[PE2] qos policy qinq
[PE2-qospolicy-qinq] classifier A30 behavior P100
[PE2-qospolicy-qinq] classifier A40 behavior P200
[PE2-qospolicy-qinq] quit
# Enable basic QinQ on the port.