H3C Technologies H3C S10500 Series Switches - Manual (Page 52)

41
To do... Use the command... Remarks
Enter system view system-view —
Create a Layer 2 aggregate
interface and enter Layer 2
aggregate interface view
interface
bridge-aggregation
interface-number
Required
When you create a Layer 2 aggregate interface,
the system automatically creates a Layer 2 static
aggregation group numbered the same.
Exit to system view quit —
Enter Layer 2 Ethernet
interface view interface interface-type
interface-number
Assign the Ethernet interface
to the aggregation group port link-aggregation
group number
Required
Repeat these two steps to assign more Layer 2
Ethernet interfaces to the aggregation group.
Assign the port an
aggregation priority link-aggregation
port-priority port-priority
Optional
By default, the aggregation priority of a port is
32768.
Changing the aggregation priority of a port might
affect the aggregation state of the ports in the
static aggregation group.
Configuring a Layer 3 static aggregation group
Follow these steps to configure a Layer 3 static aggregation group:
To do... Use the command... Remarks
Enter system view system-view —
Create a Layer 3 aggregate
interface and enter Layer 3
aggregate interface view
interface
route-aggregation
interface-number
Required
When you create a Layer 3 aggregate interface,
the system automatically creates a Layer 3 static
aggregation group numbered the same.
Exit to system view quit —
Enter Layer 3 Ethernet
interface view interface interface-type
interface-number
Assign the Ethernet interface
to the aggregation group port link-aggregation
group number
Required
Repeat these two steps to assign more Layer 3
Ethernet interfaces to the aggregation group.
Assign the port an
aggregation priority
link-aggregation
port-priority port-priority
Optional
By default, the aggregation priority of a port is
32768.
Changing the aggregation priority of a port might
affect the aggregation state of the ports in the
static aggregation group.
Configuring a dynamic aggregation group
NOTE:
To guarantee a successful dynamic aggregation, be sure that the peer ports of the ports aggregated at one
end are also aggregated. The two ends can automatically negotiate the aggregation state of each member
port.