Configuring lldp settings for ports in batch – H3C Technologies H3C WX5500E Series Access Controllers User Manual
Page 223
213
Item Description
DOT1 TLV
Setting
Port VLAN ID
Select the box to include the PVID TLV in transmitted LLDPDUs.
Protocol VLAN ID
Select the box to include port and protocol VLAN ID TLVs in transmitted
LLDPDUs and specify the VLAN IDs to be advertised.
If no VLAN is specified, the lowest protocol VLAN ID is transmitted.
VLAN Name
Select the box to include VLAN name TLVs in transmitted LLDPDUs, and
specify the VLAN IDs to be advertised.
If no VLAN is specified, the lowest VLAN carried on the port is
advertised.
DOT3 TLV
Setting
Link Aggregation
Select the box to include the link aggregation TLV in transmitted
LLDPDUs.
MAC/PHY
Configuration/Status
Select the box to include the MAC/PHY configuration/status TLV in
transmitted LLDPDUs.
Maximum Frame Size
Select the box to include the maximum frame size TLV in transmitted
LLDPDUs.
Power via MDI
Select the box to include the power via MDI TLV and power stateful
control TLV in transmitted LLDPDUs.
MED TLV
Setting
LLDP-MED
Capabilities
Select the box to include the LLDP-MED capabilities TLV in transmitted
LLDPDUs.
Inventory
Select the box to include the hardware revision TLV, firmware revision
TLV, software revision TLV, serial number TLV, manufacturer name TLV,
model name TLV and asset ID TLV in transmitted LLDPDUs.
Network Policy
Select the box to include the network policy TLV in transmitted LLDPDUs.
Extended
Power-via-MDI
Capability
Select the box to include the extended power-via-MDI TLV in transmitted
LLDPDUs.
Emergency Number
Select the box to encode the emergency call number in the location
identification TLV in transmitted LLDPDUs and set the emergency call
number.
Address
Select Address to encode the civic address information of the network
connectivity device in the location identification TLV in transmitted
LLDPDUs. In addition, set the device type which can be a switch or
LLDP-MED endpoint, country code, and network device address.
When you configure the network device address, select the address
information type from the list, enter the address information in the field
below, and click Add next to the field to add the information to the
address information list below. To remove an address information entry,
select the entry from the list, and click Delete. The civic address
information can include language, province/state, country, city, street,
house number, name, postal/zip code, room number, post office box,
and, if necessary, additional information.
Network Device
Address
Configuring LLDP settings for ports in batch
1.
Select Network > LLDP from the navigation tree.
By default, the Port Setup tab is displayed.