Configuring switch b, Verifying the configuration – H3C Technologies H3C WX5500E Series Access Controllers User Manual
Page 237
227
Configuring Switch B
1.
(Optional.) Enable LLDP on port GigabitEthernet 1/0/1. (By default, LLDP is enabled on Ethernet
ports.)
2.
Set the LLDP operating mode to Tx on GigabitEthernet 1/0/1:
a.
Select Network > LLDP from the navigation tree.
By default, the Port Setup tab is displayed.
b.
Click the icon for port GigabitEthernet1/0/1.
c.
Select Tx from the LLDP Operating Mode list.
3.
Click Apply.
A progress dialog box appears.
4.
Click Close on the progress dialog box when the progress dialog box prompts that the
configuration succeeds.
Figure 202 Setting the LLDP operating mode to Tx
5.
Enable global LLDP:
a.
Click the Global Setup tab.
b.
Select Enable from the LLDP Enable list.
6.
Click Apply.
A progress dialog box appears.
7.
Click Close on the progress dialog box when the progress dialog box prompts that the
configuration succeeds.
Verifying the configuration
1.
Display the status information of port GigabitEthernet1/0/1 on Switch A:
a.
Select Network > LLDP from the navigation tree.
By default, the Port Setup tab is displayed.