H3C Technologies H3C SecBlade LB Cards - Manual (Page 175)

165
process, the next-startup configuration file is lost. You must re-specify a new startup configuration file
after the device reboots (see " Specifying the next-startup configuration file ").
• Safe mode—Use the save command with the safely keyword. Safe mode is slower than fast mode,
but more secure. In safe mode, the system saves configuration in a temporary file and starts
overwriting the target next-startup configuration file after the save operation is complete. If a reboot
or power failure occurs during the save operation, the next-startup configuration file is still retained.
Use the safe mode if the power source is not reliable or you are remotely configuring the device.
The configuration file extension must be .cfg.
To save the running configuration, perform either of the following tasks in any view:
Task Command Remarks
Save the running configuration to a
configuration file without
specifying the file as the
next-startup configuration file.
save file-url N/A
Save the running configuration to a
configuration file and specify the
file as the next-startup
configuration file.
save [ safely ] [ force ]
If the force keyword is specified,
the command saves the
configuration to the next-startup
configuration file that has been
specified.
If the force keyword is not
specified, you may choose to
re-specify a next-startup
configuration file as instructed by
the system.
Configuring configuration rollback
To replace the running configuration with the configuration in a configuration file without rebooting the
device, use the configuration rollback function. This function helps you revert to a previous configuration
state or adapt the running configuration to different network environments.
The configuration rollback function compares the running configuration against the specified
replacement configuration file and handles configuration differences as follows:
• If a command in the running configuration is not in the replacement file, executes its undo form.
• If a command in the replacement file is not in the running configuration, adds it to the running
configuration.
• If a command has different settings in the running configuration and the configuration file, replaces
its running configuration with the setting in the configuration file.
To facilitate configuration rollback, the configuration archive function is developed. This function enables
the system to automatically save the running configuration at regular intervals as checkpoint references.
Configuration task list
Task Remarks
Configuring configuration archive parameters Required.