H3C Technologies H3C SecBlade LB Cards - Manual (Page 33)

23
Figure 19 Scheme authentication interface for Telnet login
Configuring common VTY user interface settings (optional)
You might be unable to access the CLI through a VTY user interface after configuring the auto-execute
command command on it. Before you configure the command and save the configuration, make sure you
can access the CLI through a different user interface.
To configure common settings for VTY user interfaces:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter one or multiple VTY user
interface views. user-interface vty first-number
[ last-number ]
N/A
3. Enable the terminal service. shell
Optional.
By default, terminal service is
enabled.
4. Enable the user interfaces to
support Telnet, SSH, or both of
them.
protocol inbound { all | ssh |
telnet }
Optional.
By default, both Telnet and SSH
are supported.
The configuration takes effect the
next time you log in.
5. Define a shortcut key for
terminating tasks.
escape-key { default |
character }
Optional.
By default, pressing Ctrl+C
terminates a task.
6. Configure the type of terminal
display.
terminal type { ansi | vt100 }
Optional.
By default, the terminal display
type is ANSI.