H3C Technologies H3C SecBlade LB Cards - Manual (Page 58)

48
Step Command Remarks
4. Configure the SNMP
access right.
• (Approach 1) Specify the SNMP NMS access
right directly by configuring an SNMP
community:
snmp-agent community { read | write }
community-name [ mib-view view-name ] [ acl
acl-number | acl ipv6 ipv6-acl-number ] *
• (Approach 2) Configure an SNMP group and
add a user to the SNMP group:
a. snmp-agent group { v1 | v2c }
group-name [ read-view read-view ]
[ write-view write-view ] [ notify-view
notify-view ] [ acl acl-number | acl ipv6
ipv6-acl-number ] *
b. snmp-agent usm-user { v1 | v2c }
user-name group-name [ acl acl-number
| acl ipv6 ipv6-acl-number ] *
Use either approach.
The username in approach 2
is equivalent to the
community name used in
approach 1, and must be the
same as the community name
configured on the NMS.
NMS login example
Network requirements
Configure the LB product and network management station so you can remotely manage the LB product
through SNMPv3.
Figure 36 Network diagram
Configuration procedure
1. Configure LB:
# Assign an IP address to the LB product. Make sure the LB product and the NMS can reach each
other. (Details not shown.)
# Enter system view.
<LB> system-view
# Enable the SNMP agent.
[LB] snmp-agent
# Configure an SNMP group.
[LB] snmp-agent group v3 managev3group
# Add a user to the SNMP group.
[LB] snmp-agent usm-user v3 managev3user managev3group
2. Configure the NMS: