H3C Technologies H3C SecBlade LB Cards - Manual (Page 63)

53
To configure the ACSEI client on the LB product:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable ACSEI client. acsei-client enable Disabled by default.
Displaying and maintaining ACSEI server and client
Task Command Remarks
Display ACSEI client summary on the
ACSEI server. display acsei client summary [ client-id ] [ | { begin |
exclude | include } regular-expression ] Available in
any view.
Display ACSEI client information on the
ACSEI server. display acsei client info [ client-id ] [ | { begin |
exclude | include } regular-expression ] Available in
any view.
Display information about ACSEI client
on the ACSEI client. display acsei-client information [ | { begin | exclude
| include } regular-expression ] Available in
any view.
Display the current state of ACSEI client
on the ACSEI client. display acsei-client status [ | { begin | exclude |
include } regular-expression ] Available in
any view.
Example of monitoring and managing the LB
module from the network device
Network requirements
An LB module is installed in slot 3 of the network device to detect the traffic passing the network device.
The internal interface Ten-GigabitEthernet3/0/1 on the network device is connected to the internal
interface Ten-GigabitEthernet0/0 on the LB module.
When the traffic arrives at the network device, the network device redirects it to the LB module. The LB
module processes the traffic based on the configured policy, and then redirects the traffic that passes the
detection to the network device for forwarding.
Configure the network device and LB module so that you can log in to and restart the LB module from the
network device. Configure the clock synchronization timer from the network device to the LB module as
10 minutes, and configure the monitoring timer as 10 seconds.
Figure 37 Network diagram