H3C Technologies H3C SecBlade LB Cards - Manual (Page 179)

169
• The server is reachable and enabled with TFTP service.
• You have read and write permissions.
To restore the next-startup configuration file from a TFTP server:
Step Command Remarks
1. Restore the next-startup
configuration file from a TFTP
server in user view.
restore startup-configuration from
src-addr src-filename
N/A
2. Verify that the specified
configuration file has been set
as the next-startup
configuration file.
display startup Optional.
Deleting the next-startup configuration file
CAUTION:
This task permanently deletes the next-startup configuration file from the device. Before performing this
task, back up the file as needed.
You may need to delete the next-startup configuration file for one of the following reasons:
• After you upgrade system software, the file does not match the new system software.
• The file has been corrupted or is not fully compatible with the device.
After the file is deleted, the device uses factory defaults at the next startup.
Perform the following task in user view:
Task Command
Delete the next-startup configuration file. reset saved-configuration
Displaying and maintaining a configuration file
Task Command Remarks
Display information about
configuration rollback.
display archive configuration [ |
{ begin | exclude | include }
regular-expression ]
Available in any view.
Display the running configuration.
display current-configuration
[ configuration [ configuration ] |
interface [ interface-type
[ interface-number ] ] | exclude
modules ] [ by-linenum ] [ | { begin
| exclude | include }
regular-expression ]
Available in any view.