Configuration procedure – H3C Technologies H3C SecBlade LB Cards User Manual
Page 49
39
Figure 29 Network diagram
Configuration procedure
1.
Configure LB:
# Assign the IP address 192.168.0.58 and the subnet mask 255.255.255.0 to interface
GigabitEthernet 0/1.
<LB> system-view
[LB] interface gigabitethernet 0/1
[LB-GigabitEthernet0/1] ip address 192.168.0.58 255.255.255.0
[LB-GigabitEthernet0/1] quit
# Set the password to admin for local user admin. Specify the Web service type for the local user,
and set the command level to 3 for this user.
[LB] local-user admin
[LB-luser-admin] service-type web
[LB-luser-admin] authorization-attribute level 3
[LB-luser-admin] password simple admin
2.
Verify the configuration:
# On the PC, run the Web browser. Enter the IP address of the LB product in the address bar. The
Web login page appears, as shown in
.