H3C Technologies H3C SecBlade LB Cards - Manual (Page 78)

68
Rebooting the device
CAUTION:
•
Device reboot can interrupt network services.
• To avoid data loss, save the current configuration before a reboot.
To restore the device from an error condition or place new software loaded to the device into effect, you
might need to reboot the device.
To reboot the device, use one of the following methods:
• Reboot the device immediately in the Web interface or at the CLI.
• At the CLI, schedule a reboot to occur at a specific time and date or after a delay.
• Power off and then power on the device. This method might cause data loss, and is the
least-preferred method.
Reboot in the Web interface or at the CLI enables easy remote device maintenance.
Rebooting the device in the Web interface
1. Select System > Reboot from the navigation tree.
Figure 46 Rebooting the device
2. If necessary, select Check whether the configuration is saved to the configuration file for next
reboot.
{
If you select this option, the device checks whether the configuration file for the next startup
reflects the running configuration. If yes, the device reboots. If not, a prompt is displayed and
the device does not reboot. You can save the configuration and try to reboot the device again.
{
If you do not select this option, the device directly reboots.
3. Click Apply.
A confirmation dialog box appears.
4. Confirm the reboot operation.
Rebooting the device immediately at the CLI
To reboot a device, execute the following command in user view: