LinPlug RMV - Manual (Page 133)

Setup Panel
Pad Setup
The Pad Setup section is used to set the position in which Pads appear when a Kit file is
loaded. For example, a Kit can be setup so that Pad 1 always contains a kick drum, or that
Pad 2 always contains a snare drum, regardless of the actual Kit file that is loaded. This
means that no matter how the kit was saved, when it is loaded, each Pad will appear
where the user wants it to appear. This capability is also useful if the RMV is used with a
hardware controller such as the M-Audio Trigger Finger or any of the AKAI MPD/MPC
controllers. In this case, the RMV can be setup so that the contents of the Pads is
consistent from Kit to Kit. In other words, Pad 1 of the hardware device will always trigger
a kick drum sound, or Pad 2 will always trigger a snare drum sound.
The Pad Setup section contains two sets of controls. The first set of controls are located at
the top of the section and are used to selecting the current Pad Setup. The second set of
controls, called the Pad Matrix, are located below the Pad Setup buttons and are used for
arranging the contents of the RMV's Pads.
Current Pad Setup: The Current Pad Setup buttons are used to select the Pad
arrangement that is used when a Kit is loaded. Four User Presets are
available: U1, U2, U3 and U4. The Current Pad Setup can also be
set to Off in which case the Pad is arranged according to its default
settings. Note that the Pad Setup is stored in the RMV itself and is
not part of the Kit data. To create a new Pad Setup, choose one of
the User Presets (U1, U2, U3, U4) and then rearrange the Pads
according to the method described below.
LinPlug Reference Manual 5.0.1 133