LinPlug RMV - Manual (Page 88)

Signal Path
that the length of the sustain phase cannot be displayed exactly as it
depends on when the instrument receives a Note-Off message. It is
shown in the display merely as an example.
T: The T slider sets the envelope's Sustain Time. When set to its
maximum value the sustain time is infinite, that is, it is controlled by
the MIDI Note Off command that trigger the Pad. It is also possible to
set a sustain time after that is independent of the MIDI Note off that
triggered the Pad.
R(elease): The Release slider determines the length of time that the filter cutoff
frequency takes to move from the Sustain frequency to 0 envelope
depth after a Note-Off message has been received.
Release Envelope Shape: The Release dial has a corresponding “curve” control located
above it that is used to set the shape of the envelope segment. The
shape of the segment can range from extreme negative exponential
to extreme positive exponential. To adjust the “curve” setting, click on
the control and drag the cursor up or down. The change in the
curve's shape will be shown on the control.
Don't forget that the filter's AHDSTR envelope is shown using a blue line in the Sampler
Display when the display is in "Waveform" mode and the Filter is switched On.
LinPlug Reference Manual 5.0.1 88