LinPlug RMV - Manual (Page 49)

Audio Modules
Claps
The Claps module uses short noise bursts and a longer noise tail to create a characteristic
electronic "clap" sound.
The Claps module contains the following controls:
Gap: The Gap control is used to set the length of time between the noise
bursts that produce the "clap" sound. Rotating the control in a
clockwise direction increases the length of time between the noise
bursts.
Release: The Release control is used to determine the duration of the release
portion of the clap signal's noise tail. Rotating the control in a
clockwise direction increases the duration of the release portion of
the clap's noise signal.
Claps: The Claps control is used to set the number of claps produced by the
Clap module. Setting this to higher values increases the number of
claps and thickens the sound.
Decay: The Decay control is used to set the rate at which the single noise
bursts decay to silence. Rotating the control in a clockwise direction
increases the decay time of each noise burst.
Colour: The Colour control is used to set the frequency spectrum of the clap
noise oscillator. Rotating the control is a clockwise direction
increases the spectral content of the clap noise oscillator.
LinPlug Reference Manual 5.0.1 49