LinPlug RMV User Manual
Page 75
Loop Module
signal sent to the Effects Rack selected using the Snd1 Destination
control is set using the Snd1 Amount control.
Snd1 Destination:
The Snd1 Destination control is used to set the destination of a Pad's
first Effects Send. Three destinations, Snd1, Snd2 and Snd3 are
available. Each corresponds to one of the RMV's three Send Effects
Racks. Note that only one destination is active at a time.
Snd2 :
Each Pad can send its output to the Effects Racks in the RMV's Send
Effects section (see the Send Effects section of this manual for more
information about the RMV's Send Effects). The percentage of the
signal sent to the Effects Rack selected using the Snd2 Destination
control is set using the Snd2 Amount control.
Snd2 Destination:
The Snd2 Destination control is used to set the destination of a Pad's
second Effects Send. Three destinations, Snd1, Snd2 and Snd3 are
available. Each corresponds to one of the RMV's three Send Effects
Racks. Note that only one destination is active at a time.
LinPlug
Reference Manual 5.0.1
75