LinPlug RMV - Manual (Page 87)

Signal Path
Filter Envelope
The Filter Env(elope) section is located to the right of the Filter section.
It consists of 9 controls for setting the filter envelope parameters. These are described
below:
A(ttack): The Attack slider determines the length of time it takes for the filter
cutoff frequency to move from its initial value to the full envelope
depth. For example, if the Attack slider is set to 0.100 seconds, the
cutoff frequency will move from its initial value to full envelope depth
within 100 milliseconds.
Attack Envelope Shape: The Attack dial has a corresponding “curve” control located
above it that is used to set the shape of the envelope segment. The
shape of the segment can range from extreme negative exponential
to extreme positive exponential. To adjust the “curve” setting, click on
the control and drag the cursor up or down. The change in the
curve's shape will be shown on the control.
H(old): The Hold slider determines the length of time the filter cutoff
frequency is held at the maximum envelope depth.
D(ecay): The Decay slider determines the length of time that the filter cutoff
frequency takes to move from the full envelope depth to the Sustain
frequency after the Hold time has elapsed.
Decay Envelope Shape: The Decay dial has a corresponding “curve” control located
above it that is used to set the shape of the envelope segment. The
shape of the segment can range from extreme negative exponential
to extreme positive exponential. To adjust the “curve” setting, click on
the control and drag the cursor up or down. The change in the
curve's shape will be shown on the control.
S(ustain): The Sustain slider determines the frequency that the filter cutoff is
held at during the Sustain portion of the envelope. It should be noted
LinPlug Reference Manual 5.0.1 87