LinPlug RMV - Manual (Page 60)

Audio Modules
is too long to be displayed in the window. This, of course, depends on the current
magnification setting.
Sample: The Sample parameter displays the name of the currently loaded
sample. Note that the name of the currently active Sample Slot is
highlighted.
Clear: To the right of the sample's name is the "Clear" button ( "X" icon).
Clicking on this button allows you to remove the currently loaded
sample from the selected slot.
Sample Start: The point in the file at which playback starts can be set in two
different ways. The first way is be dragging the start point cursor to
the required position. The second way is by setting the “Start” control
to the desired numeric value (in samples).
Sample End: The point in the file at which playback ends can be set in two
different ways. The first way is be dragging the end point cursor to
the required position. The second way is by setting the “End” control
to the desired numeric value (in samples).
Snap to Zero Crossing: The setting of the Snapping Zero Crossing button determines
whether sample start and end cursors automatically “snap” to the
nearest zero crossing point or not. When switched on, (the default
setting) sample start and end cursors can only be set to a zero-
crossing point within the sample. This produces a smoother, more
natural sound. When the Zero Crossing button is switched off,
sample start and end cursors can be placed at any point within the
waveform. This can be used to produce aggressive or "clicky"
sounds.
View: Clicking on the "View" symbol at the far right of each sample slot
(assuming that a sample is loaded into the "Slot") changes the
display from "Table" mode to "Waveform" mode and vice-versa.
Pitch Envelope, Amplitude Envelope and Filter Envelope
The Waveform view shows the sample's waveform, along with the Pad's amplitude, and
pitch envelopes. The amplitude envelope is shown as a grey envelope behind the sample.
The pitch envelope is calculated directly into the sample and is not shown as a separate
envelope. If the filter is on, its envelope is shown as a blue line.
LinPlug Reference Manual 5.0.1 60