LinPlug RMV - Manual (Page 53)

Audio Modules
Drum Synth
The modules described above are designed to produce a specific type of percussion
sound. Because of this they do not offer certain parameters, and the parameters that are
available are limited to specific ranges. The Drum Synth module is unlike these modules
as it has been designed as a “universal drum synthesizer”. This means that it has features
not found in any of the other synthesis modules. The Drum Synth module is based on one
conventional oscillator and one noise oscillator. Each oscillator can be delayed relative to
the other, and can be modulated using an envelope and a fast LFO at the same time. The
modulation controls are unusual in that they have extremely large depth and time ranges.
The Drum Synth module contains the following controls:
Oscillator Wave: The Oscillator Wave control is used to set the oscillator's waveform.
Three waveforms are available: Sawtooth, Triangle and Sine.
Oscillator Freq(uency): The Oscillator Freq(uency) control is used to set the frequency of
the oscillator. The available range is 20 Hz to 20000 Hz.
Oscillator Phase: The Oscillator Phase control is used to set the point in the waveform
cycle at which the wave starts when the oscillator is triggered. The
available range is 0 degrees to 360 degrees which represent one
complete waveform cycle.
Oscillator Delay: The Oscillator Delay control is used to set the delay time between the
triggering of the oscillator and the time it starts playing.
LinPlug Reference Manual 5.0.1 53