PLANET ISW-1022MPT - Manual (Page 141)

User’s Manual of ISW-1022M Series and ISW-1033MT
6.3 Trunk Commands Set
Commands Level Description Example
aggregator priority
[1~65535]
G Set port group system priority switch(config)#aggregator priority 22
aggregator activityport
[Group ID]
[Port Numbers]
G Set activity port switch(config)#aggregator activityport 2
aggregator group
[GroupID] [Port-list]
lacp
workp
[Workport]
G Assign a trunk group with
LACP active.
[GroupID] :1~3
[Port-list]:Member port list,
This parameter could be a port
range(ex.1-4) or a port list
separate by a comma(ex.2, 3,
6)
[Workport]: The amount of
work ports, this value could
not be less than zero or be
large than the amount of
member ports.
switch(config)#aggregator group 1 1-4 lacp
workp 2
or
switch(config)#aggregator group 2 1,4,3 lacp
workp 3
aggregator group
[GroupID] [Port-list]
nolacp
G Assign a static trunk group.
[GroupID] :1~3
[Port-list]:Member port list,
This parameter could be a port
range(ex.1-4) or a port list
separate by a comma(ex.2, 3,
6)
switch(config)#aggregator group 1 2-4
nolacp
or
switch(config)#aggregator group 1 3,1,2
nolacp
show aggregator P Show the information of trunk
group
switch#show aggregator 1
or
switch#show aggregator 2
or
switch#show aggregator 3
no aggregator lacp
[GroupID]
G Disable the LACP function of
trunk group
switch(config)#no aggreator lacp 1
no aggregator group
[GroupID]
G Remove a trunk group switch(config)#no aggreator group 2
141