PLANET ISW-1022MPT - Manual (Page 46)

User’s Manual of ISW-1022M Series and ISW-1033MT
46
4.5 Commands Level
Modes Access Method Prompt Exit Method About This Mode1
User EXEC
Begin a session
with your switch.
switch>
Enter logout or
quit.
The user commands available
at the user level are a subset of
those available at the
privileged level.
Use this mode to:
• Perform basic tests.
• Display system information.
Privileged
EXEC
Enter the enable
command while in
User EXEC mode.
switch#
Enter disable to
exit.
The privileged command is the
advanced mode.
Use this mode to
• Display advanced function
status
• Save configuration
Global
Configuration
Enter the configure
command while in
privileged EXEC
mode.
switch (config)#
To exit to
privileged EXEC
mode, enter exit
or end
Use this mode to configure
those parameters that are
going to be applied to your
switch.
VLAN database
Enter the vlan
database command
while in privileged
EXEC mode.
switch (vlan)#
To exit to user
EXEC mode,
enter exit.
Use this mode to configure
VLAN-specific parameters.
Interface
configuration
Enter the interface
of fast Ethernet
command (with a
specific interface)
while in global
configuration mode.
switch
(config-if)#
To exit to global
configuration
mode, enter exit.
To exit to
privileged EXEC
mode, enter exit
or end.
Use this mode to configure
parameters for the switch and
Ethernet ports.