PLANET ISW-1022MPT - Manual (Page 76)

User’s Manual of ISW-1022M Series and ISW-1033MT
76
5.5.3.3 State Activity
Having set up the LACP aggregator on the tab of Aggregator Setting, you can configure the state activity for the members
of the LACP trunk group. You can tick or cancel the checkbox beside the state label. When you remove the tick mark of
the port and click Apply , the port state activity will change to Passive.
Figure 5-26 State Activity of Switch 1
The page includes the following fields:
Object Description
Active: The port automatically sends LACP protocol packets.
Passive:
The port does not automatically send LACP protocol packets, and responds only
if it receives LACP protocol packets from the opposite device.
Figure 5-27 State Activity of Switch 2
A link having two passive LACP nodes will not perform dynamic LACP trunk because both
ports are waiting for an LACP protocol packet from the opposite device.