PLANET ISW-1022MPT - Manual (Page 78)

User’s Manual of ISW-1022M Series and ISW-1033MT
78
5.5.5 Rate Limiting
You can set up every port’s bandwidth rate and frame limitation type.
„
Ingress Limit Frame type: select the frame type that wants to filter. There are four frame types for selecting:
¾
All
¾
Broadcast/Multicast/Flooded Unicast
¾
Broadcast/Multicast
¾
Broadcast only
Broadcast/Multicast/Flooded Unicast, Broadcast/Multicast and Bbroadcast only types are only for ingress
frames. The egress rate only supports All type.
Figure 5-29 Rate Limiting interface
„
All the ports support port ingress and egress rate control. For example, assume port 1 is 10Mbps, users can
set it’s effective egress rate is 1Mbps, ingress rate is 500Kbps. The switch performs the ingress rate by packet
counter to meet the specified rate
¾
Ingress: Enter the port effective ingress rate (The default value is “0”).
¾
Egress: Enter the port effective egress rate (The default value is “0”).
„ And then, click Apply to apply the settings