Zoom H4n Pro 4-Input / 4-Track Portable Handy Recorder Kit with Protective Case (Black) - Manual (Page 138)

142
Reference / MTR mode effect types and parameters
● Bass preamp effects
SVT Models the sound of the Ampeg SVT.
BASSMAN Models the sound of the Fender Bassman 100.
SMR Models the sound of the SWR SM-900.
SUP-BASS Models the sound of the Marshall Super Bass.
SANSAMP Models the sound of the SansAmp Bass Driver DI.
TUBE PRE ZOOM original tube preamp sound
The 6 effects above have the same parameters.
(1) CABINET 0–2 Adjusts the depth of the speaker cabinet sound.
(2) GAIN 0–100 Adjusts the preamp gain (distortion depth).
(3) BASS −12–+12 Adjusts the low-frequency boost/cut.
(4) MIDDLE −12–+12 Adjusts the middle-frequency boost/cut.
(5) TREBLE −12–+12 Adjusts the high-frequency boost/cut.
(6) BALANCE 0–100
Adjusts the balance between the signals before
and after they pass through the module The
higher the value, the greater the post-module
signal amount.
(7) LEVEL 1–100
Sets the level of the signal after the PREAMP
module.
(8) ZNR
(ZOOM Noise Reduction)
OFF, 1–16
Adjusts the sensitivity of ZOOM's original ZNR
noise reduction effect.
· Manufacturer and product names shown in these tables are the trademarks and registered
trademarks of various companies. The names are used only to explain sonic characteristics
and do not indicate any affiliation with Zoom Corporation.
● Mic preamp effects
VO MPRE Preamp with characteristics good for vocal recording
AG MPRE Preamp with characteristics good for acoustic guitar recording
FlatMPRE Preamp with flat characteristics
The 3 effects above have the same parameters.
(1) COMP
OFF,
1–10
Adjusts the compression of the total signal level
by lowering high-level signals and raising low-
level signals.
(2) DE-ESSER
OFF,
1–10
Adjusts the amount that sibilant sounds are cut.
(3) LOW CUT
OFF,
1–10
Adjusts the frequency of the filter that cuts
low-frequency noise, which is easily picked up
by mics.
(4) BASS −12–+12 Adjusts the low-frequency boost/cut.
(5) MIDDLE −12–+12 Adjusts the middle-frequency boost/cut.
(6) TREBLE −12–+12 Adjusts the high-frequency boost/cut.
(7) LEVEL 1–100
Sets the level of the signal after the PREAMP
module.
(8) ZNR
(ZOOM Noise Reduction)
OFF,
1–16
Adjusts the sensitivity of ZOOM's original ZNR
noise reduction effect.