Honeywell SMV 3000 - Manual (Page 24)

12 SMV 3000 Transmitter User’s Manual 1/99
2.2 Getting SMV 3000 Transmitter On-Line Quickly
Quick Start-up Tasks Table 1 lists common start-up tasks for an SMV 3000 transmitter using the
SCT and gives an appropriate section in this manual to reference for more
information about how to do the task. The start-up tasks are listed in the
order they are commonly completed.
Table 1 Start-up Tasks Reference
Task Description Reference Section
1 Put analog loop into manual
mode. Appropriate vendor documentation
for controller or recorder used as a
receiver in analog loop with
SMV 3000 transmitter.
2 Connect SCT to transmitter and
establish communications 5.2
3 Identify transmitter’s mode of
operation. 5.3
4 Change mode of operation, if
required. 5.3
5 Check/set output conformity
(Linear/Square Root) for PV1. 6.6
6 Check/set damping times for all
PVs. 6.6 (for PV1)
6.7 (for PV2)
6.8 (for PV3)
6.9 (for PV4)
7 Check/set Probe Configuration
for PV3 6.8
8 Check/set PV4 Algorithm 6.9, 6.10, 6.11
9 Check/set Lower Range Values
and Upper Range Values for all
PVs. 6.6 (for PV1)
6.7 (for PV2)
6.8 (for PV3)
6.9 (for PV4)
10 Select PV to represent output for
transmitter in analog mode only. 6.5
11 Run optional output check for
analog loop. 7.3
12 Perform start-up procedures -
Check zero input and set, if
required. 7.5
13 Check transmitter status, access
operating data. 8.2