MACKIE HDR24/96 - Manual (Page 18)

HDR 24/96
The Remote 48 Autolocator section
TIME UNITS
The TIME UNITS key toggles the time display mode between SMPTE and BBT. This also
changes the display for the GUI and front panel.
EDIT TIME
The EDIT TIME key allows you to edit specific fields within the LOCATE TIME display.
Pressing EDIT TIME once selects the Frames/Ticks field, a second time the Seconds/Beats
field, and so on. The selected field flashes until the field is advanced (with the EDIT TIME
button) or the Locate Time is set by pressing ENTER.
Time fields can be edited in three ways:
1) Numeric entry from keypad. Numbers shift left continually until field value is
set with Time Field or Enter button
2) + and – keys. Pressing + (+/NEXT) advances value by 1, pressing – (–/PREV)
decrements value by 1; holding the + or – key scrolls the value up or down.
3) Rotating the WHEEL. Numbers increment or decrement continually as WHEEL
is rotated.
+/NEXT and -/PREV
The +/Next and –/Prev keys perform three functions:
1) Act as math operators for adding (+) and subtracting (–) time code values from
LOCATE TIME display
2) Act as trim keys for incrementing or decrementing Locate Time field values
3) Act as keys for cycling through Cues in specific Autolocator operations.
The use of each of these keys is documented within the specific Autolocator functions.
Numeric Keypad
The numeric keypad is used for entering time values or Cue numbers into the Locate Time or
Cue displays, respectively. The specific use of the numeric keypad is documented within the
HDR 24/96 18