MACKIE HDR24/96 - Manual (Page 99)

HDR 24/96
The entire selection (at its present length) can be repositioned by dragging the gray area on the
time bar.
Selection area on a single track
Multitrack Area Selection
To make the same selection on multiple tracks, after an area is selected on one track,
[C
TRL +click] anywhere in another track’s area or on the track's blue selection button to
duplicate the selection on the other track. [S HIFT +click]ing on another track will duplicate
the selection on all the tracks between the first one selected and the one on which the mouse
pointer is clicked.
Selection Range Display
The Selection Range Start and End time fields in the Tools panel show start and end times of
the area currently selected via the I-beam tool. This time display is interactive with the
selected area. The area boundaries can be updated by editing the numbers in the time fields.
Conversely, as the selection boundaries are changed by dragging with the mouse, the time
fields are updated.
The time fields in the Selection Range Display can be edited in the GUI Tools panel as
follows:
Click on the desired field in the Selection Range
display to highlight the pair of digits you wish to
modify. Change the numbers by dragging the
mouse up or down over the highlighted digits or by
direct numeric entry from the keyboard. Navigate
between hours, minutes, and seconds fields with
the
[T AB ] or [S HIFT +T AB ] key or mouse. Complete
the data entry with the [E NTER ] key or by clicking
in the Tools panel background area.
NOTE: If you manually enter a Start time that is later than the current End time, or
conversely if you enter an End time that is earlier, the two times will be swapped – i.e. the
time you entered for End time will become the Start time and vice versa.. The switch does
Technical Reference 99