MACKIE HDR24/96 - Manual (Page 19)

HDR 24/96
specific Autolocator functions. See the description of the Cue display above, and the section
on Cues in the.
CLEAR
The CLEAR key deletes the last value entered into the Locate Time or Cue Number display
by shifting all of the numbers right by one character. When entering time into the LOCATE
TIME display, pressing CLEAR after the last character is deleted cancels the operation and
restores the previous Locate Time value.
ENTER
The ENTER key is used for four functions:
1) Terminates the entry of a string of numbers when entering a time in the LOCATE
TIME display
2) Executes the Recall of a previewed value (Cues, numbered Locates, Pre-Roll, last
Play, etc.) from the LOCATE TIME display to the actual Locate Time value
3) Executes a Cue Store or New Cue operation
4) Acts as an equals sign (“=”) to complete time code calculator operations.
The specific use of the ENTER key is documented throughout the various Autolocator
functions.
STORE
The STORE button is used to store the value of the Locate Time or Tape Time into Cues,
numbered Locates, Pre-Roll time, and the Loop and Punch lengths. The exact sequence of
the Store operation will vary somewhat depending on what time is being stored where.
Pressing STORE once selects the Locate Time, and pressing STORE twice (or
CTRL+STORE) selects the Tape Time as the source time for the store operation. A flashing
dot in the right of the TAPE TIME or LOCATE TIME display indicates which time is
selected. The STORE LED blinks while the Store operation is in progress (armed for
storing). Pressing STORE yet again (third time) will cancel the operation. The source time
value is copied to the destination, and the STORE LED is turned off, when the last key in the
sequence is pressed (ENTER for Cues, LOC n for Numbered Locates, or PRE ROLL, LOOP,
or PUNCH respectively for these length parameters). The specific function of
Store (page
70) is documented with the Autolocator functions.
RECALL
The RECALL key is used to call up the value of stored time locations/values into the
LOCATE TIME display (for preview) and into the Locate Time register (when combined
with ENTER). The RECALL LED blinks when Recall/Preview is in progress, and goes out
after Recall is executed (ENTER) or canceled (by pressing RECALL again). If a valid Cue
number is typed in during Recall/Preview the LOCATE TIME display will automatically
present the time for that Cue. If the user types in the value of a non-existent Cue, then the
Locate Time shows dashes (“- - –“) until a valid Cue or other stored value is selected. The
specific function of
Recall (page 71) is documented with the Autolocator functions.
CAPTURE
Pressing CAPTURE transfers the instantaneous value of Tape Time (Current Time) into the
Locate Time. No ENTER key press is required as the Tape Time provides its own form of
continuous preview.
Technical Reference 19