Inter-Tel Axxess - Manual (Page 13)

Page ix
FCC Regulations
AXXESS ® ADMINISTRATOR’S GUIDE – January 2004
5. If trouble is experienced with this equipment, contact a local authorized factory service
representative for repairs and/or warranty information. The customer, users, and unau-
thorized technicians should not repair, make adjustments to, or attempt to service this
equipment in any way.
6. In the event of trouble with the telephone line(s), this equipment must be disconnected
from the telephone line(s). If trouble ceases, the equipment must be repaired by an
authorized factory service representative. If the trouble continues to occur with the
equipment disconnected, the telephone company should be notified that they have a
problem. If this is the case, repairs or adjustments made by the telephone company will
be made at their expense.
7. Allowing this equipment to be operated in such a manner as to not provide proper
answer supervision signaling is in violation of Part 68 of FCC rules. This equipment
returns answer supervision signals to the public telephone network when: answered by
the called station, answered by the attendant, routed to a recorded announcement that
can be administered by the equipment user, and routed to a dial prompt. This equipment
also returns answer supervision on all DID calls forwarded back to the public telephone
network. Permissible exceptions are: a call is unanswered, busy tone is received, and
reorder tone is received.
8. This equipment is capable of providing users access to interstate providers of operator
services through the use of equal access codes. Failure to provide equal access capabili-
ties is a violation of the Telephone Operator Consumer Services Improvement Act of
1990 and Part 68 of the FCC Rules.
TYPE OF PORT
INTERFACE
FACILITY INTERFACE
CODE (FIC)
RINGER EQUIV
ALENCE NO. (REN)
SERVICE ORDER
CODE (SOC)
USOC JACK
CONNECTOR
2-Wire Loop 02LS2 0.6B – RJ21X
2-Wire Loop/Ground 02LS2/02GS2 3.6B/4.4B – RJ21X
2-Wire Ground 02GS2 0.6B – RJ21X
OPX Class C* 0L13C – 9.0F RJ11C, RJ21X
2-Wire DID** 02RV2-T 0.0B AS.2 RJ11C, RJ21X
D4 Superframe/AMI 04DU9-BN – 6.0Y RJ48C
D4 Superframe with
B8ZS
04DU9-DN – 6.0Y RJ48C
Extended
Superframe (ESF)
04DU9-1KN – 6.0Y RJ48C
ESF with B8ZS 04DU9-1SN – 6.0Y RJ48C
Primary Rate ISDN 04DU9-1SN – 6.0Y RJ48C
* Also interfaces with Class A and B.
** When using T1 facilities to provide DID service, do not use the DID facility interface code (FIC); instead, pro-
vide the telephone company with DID answer supervision code “AS.2” and the FIC for the requested T1 service.