Inter-Tel Axxess User Manual
Page 184
Page 168
System Features
AXXESS
®
ADMINISTRATOR’S GUIDE – January 2004
User-Programmable Feature Buttons
3.
Enter the feature code or extension number to be stored under that button. (If program-
ming the
button, only Call Forwarding feature codes 355-358 will be accepted.)
You hear a single progress tone when the programming is completed. Display phones
show the newly programmed feature. If you attempt to program a non-programmable
button or enter an invalid code, you will hear repeating reorder tones, and the feature
code assigned to the button will remain unchanged. Display phones show NON-PRO-
GRAMMABLE KEY or FEATURE CODE INVALID.
NOTE:
If you do not enter a feature code, the programming mode times out when the
Long Interdigit timer expires; the feature code assigned to the button remains
unchanged.
4.
To program other buttons, repeat the procedure.
NOTE:
Speed-dial buttons are programmed using the procedure shown below. Entering an
extension number, using the above instructions, will create a DSS/BLF button for that extension
number, not a speed-dial button (even if the button was previously programmed as a speed-dial
button).
T
O
CREATE
A
SPEED
-
DIAL
LOCATION
IN
A
USER
-
PROGRAMMABLE
BUTTON
:
1.
While on hook, enter the Program Keys feature code (397). Display phones show
PRESS THE KEY TO PROGRAM.
2.
Press the desired feature button. The display shows the current feature, user, or speed
dial location name and KEY VALUE: (feature or name).
3.
Enter the Station Speed-Dial feature code (382) or the System Speed-Dial feature code
(381). The display shows SELECT STN SPEED or SELECT SYS SPEED.
4.
Enter the desired speed-dial bin number (0-9 for station, 000-999 for system). The dis-
play shows the current contents of that bin.
5.
To program a new number in a station speed-dial bin, follow the instructions given on
. Administrators can use the procedures on
to program system speed-
dial locations.
FWD