Inter-Tel Axxess User Manual
Page 42
Page 26
Administrator Procedures
AXXESS
®
ADMINISTRATOR’S GUIDE – January 2004
Trunk Programming
4.
To Program an Individual Trunk: Press
or the INDIVIDUAL TRUNK menu but-
ton. Then program trunk options as follows:
a. The display shows ENTER TRUNK EXTENSION. Enter the extension number of
the trunk to be programmed using one of the methods described on
.
b. The display shows INDIVIDUAL TRUNK OPTION. Enter one of the following
options. To view the last two options on a display phone, press the arrow (<< or
>>) menu button at the bottom of the display.
Answer Supervision: To program the answer supervision for the trunk, press
or
the ANS SUPERVISION menu button. When the display shows ANS SUPERVI-
SION OPTION, press
or the POLARITY REVERSE menu button for the
polarity-reversal supervision type. Or, press
or the VALID CALL menu button
for Valid Call timer supervision. Or, press
or the VALID + POLARITY menu
button for Valid Call timer with Polarity Reversal supervision. Then press
or
ACCEPT to continue.
Caller ID: To enable or disable Caller ID, press
or the CALLER ID menu but-
ton. When the display shows SET CALLER ID, press
or ON to enable the fea-
ture, or press
or OFF to disable it. Then press
or ACCEPT to continue.
Hybrid Balance: To set the hybrid balance of the trunk to normal or short, press
or the HYBRID BALANCE menu button. When the display shows HYBRID
BALANCE OPTION, press
or the NORMAL menu button, or press
or the
SHORT menu button. Then press
or ACCEPT to continue.
DTMF/Dial-Pulse Signaling: To set the trunk for DTMF or dial-pulse signaling,
press
or the SIGNALING menu button. When the display shows ENTER SIG-
NALING OPTION, press
or the DTMF menu button, or press
or the
PULSE menu button. Then press
or ACCEPT to continue.
Trunk Group Number: To assign the trunk to a trunk group, press
or the
TRUNK GROUP menu button. When the display shows ENTER TRUNK GRP
EXTENSION, enter the desired trunk group number using one of the methods
described on
Busy Trunk: To temporarily remove the trunk from service, press
or the BUSY
TRUNK menu button. When the display shows MARK TRUNK BUSY, press
or the ON menu button, or press
or the OFF menu button. Then press
or
ACCEPT to continue.
c. To exit, press
or ACCEPT to move backward through the prompts until you
reach the ENTER DATABASE OPTION prompt.
5.
To Program A Trunk Group: Press
or the TRUNK GROUP menu button. Then
program the trunk group, as follows:
a. The display shows ENTER TRUNK GRP EXTENSION. Enter the extension num-
ber of the trunk group to be programmed using one of the methods described on
b. The display shows ENTER TRUNK GROUP OPTION. Select one of the following
options. To view the last three options on a display phone, press the arrow (<< or
>>) menu button at the bottom of the display.
1
1
1
2
3
#
2
1
2
#
3
1
2
#
4
1
2
#
5
6
1
2
#
#
2