Sony MDM-X4 - Manual (Page 13)

13 EN
Connections and Signal Flow
Connections for Recording
Connect instruments, microphones, and amp and
headphones for monitoring as shown below.
When inputting sound from a sound module into this
unit
You can mix the sound with sounds previously
recorded on tracks 1~4 by using the INPUT CH-5 or
INPUT CH-6 jacks.
Do the following when connecting an external effector
to input the return sound.
To output sound to the effector : Use the AUX 1 or
AUX 2 jacks on the top panel of this unit.
To input sound from the effector (return sound) : Use
the RETURN 1 or RETURN 2 jacks on the top panel
of this unit.
Turning on the Power
After you have completed all connections, connect the
power cord from this unit to a wall outlet.
External amplifier and speakers
From the MONITOR OUT jacks
on the rear panel of this unit
From the HEADPHONES jacks
on the front panel of this unit
Headphones for monitoring
From the STEREO OUT jacks
on the rear panel of this unit
Recording equipment for use in
mixdown
• DAT recorder
• MD recorder
Instruments or microphones
To INPUT CH1~CH 6 jacks
(You can use XLR type plugs
with CH-1 and CH-2)