Sony MDM-X4 - Manual (Page 32)

32 EN
Editing Part of a Song (Track Edit)
2
Press MARK.
The indicator on the MARK key starts blinking.
3
Press the key for the locate point you desire.
• IN point : Press IN.
• OUT point : Press OUT.
• DEST (destination) point : Hold down the
SHIFT key and press IN.
• A~D (E~H) points : Press A~D (Hold down the
SHIFT key and press A~D).
The time/bar in the display is set as the respective
locate point.
Setting edit points while listening to the
sound being played back
Use the following procedure to set locate points while
listening to the sound being played back.
1
Press ( PLAY.
Playback begins.
2 Press MARK before setting the locate point.
The indicator on the MARK key starts blinking.
3
Press the key for the locate point you desire.
• IN point : Press IN.
• OUT point : Press OUT.
• DEST (destination) point : Hold down the
SHIFT key and press IN.
• A~D (E~H) points : Press A~D (Hold down the
SHIFT key and press A~D).
The locate point is set at the place where you
press the IN, OUT ,DEST or A~D (E~H) key.
Correcting the position of the locate point
1 Press the key for the point you wish to correct.
• IN point : Press IN.
• OUT point : Press OUT.
• DEST (destination) point : Hold down the
SHIFT key and press IN.
• A~D (E~H) points : Press A~D (Hold down the
SHIFT key and press A~D).
The time/bar for the respective locate point
appears in the display.
2
Press RHSL.
The indicator on the RHSL key starts to blink and
playback repeats around the locate point.
• When the rehearsal mode (page 18) setting is Â:
the volume increases when the locate point is
passed.
• When the rehearsal mode (page 18) setting is µ:
the volume decreases when the locate point is
passed.
1,5
3
2
4
Playback
start point
Locate point
Playback
end point
Change in volume
(about 12 dB)
Roll time as set in
the system setting
Playback
start point
Locate point
Playback
end point
Change in volume
(about 12 dB)
Roll time as set in
the system setting
3
1
2