SMC Networks ElliteConnect 2.4GHz/5GHz - Manual (Page 244)

Command Line Interface
7-74
• Since end-nodes cannot cause forwarding loops, they can
be passed through the spanning tree state changes more
quickly than allowed by standard convergence time. Fast
forwarding can achieve quicker convergence for end-node
devices, and also overcome other STP related timeout
problems. (Remember that fast forwarding should only be
enabled for ports connected to a LAN segment that is at the
end of a bridged LAN or for an end-node device.)
Example
bridge stp-port spanning-disabled
This command disables the Spanning Tree Protocol for the
specified interface. Use the no form to reenable the Spanning
Tree Protocol for the specified interface.
Syntax
bridge stp-port spanning-disabled <port>
no bridge stp-port spanning-disabled <port>
port - Specifies the port number on the wireless bridge.
(Range: 0, Ethernet interface; 1-16 wireless interface)
Default Setting
Enabled
Command Mode
Global Configuration
Example
This example disables the Spanning Tree Protocol for port 5.
AP(config)#bridge stp-port portfast 15
AP(config)#
AP(config)#bridge stp-port spanning-disabled 5
AP(config)#