SMC Networks ElliteConnect 2.4GHz/5GHz - Manual (Page 282)

Command Line Interface
7-112
key
This command sets the keys used for WEP and AES encryption.
Use the no form to delete a configured key.
Syntax
key {wep <index size type wep-value> | wdsaes <port-id
aes-value>}
no key {wep <index> | wdsaes}
• wep - The keyword that specifies a WEP encryption key.
– index - Key index. (Range: 1-4)
– size - Key size. (Options: 64, 128, or 152 bits)
– type - Input format. (Options: ASCII, HEX)
– wep-value - The WEP key string. For ASCII input, use 5/
13/16 alphanumeric characters for 64/128/152 bit keys.
For HEX input, use 10/26/32 hexadecimal digits for 64/
128/152 bit keys.
• wdsaes - The keyword that specifies an AES encryption key
– port-id - The ID for the wireless port on the bridge. For
Slave units, the ID is 1. For Master units, the ID can be
from 1 to 16.
– aes-value - The AES key string. For alphanumeric input,
use 8 to 31 characters. For hexadecimal input, use exactly
32 digits.
Default Setting
None
Command Mode
Interface Configuration (Wireless)
Command Usage
• To enable WEP encryption, use the encryption command
to specify the key type and length, and use the key
command to configure at least one key.