SMC Networks ElliteConnect 2.4GHz/5GHz - Manual (Page 264)

Command Line Interface
7-94
• You must assign an IP address to this device to gain
management access over the network or to connect the
wireless bridge to existing IP subnets. You can manually
configure a specific IP address using this command, or
direct the device to obtain an address from a DHCP server
using the ip dhcp command. Valid IP addresses consist of
four numbers, 0 to 255, separated by periods. Anything
outside this format will not be accepted by the configuration
program.
Example
Related Commands
ip dhcp (page 7-94)
ip dhcp
This command enables the access point to obtain an IP address
from a DHCP server. Use the no form to restore the default IP
address.
Syntax
ip dhcp
no ip dhcp
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet)
AP(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
AP(if-ethernet)#ip address 192.168.1.2 255.255.255.0
192.168.1.253
AP(if-ethernet)#