Testing basic link operation, Mount the unit, Using the pole-mounting bracket – SMC Networks ElliteConnect 2.4GHz/5GHz User Manual
Page 54: Testing basic link operation -2 mount the unit -2, Using the pole-mounting bracket -2
Hardware Installation
4-2
5.
Align antennas at both ends of the link.
Testing Basic Link Operation
Set up the units over a very short range (15 to 25 feet), either
outdoors or indoors. Connect the units as indicated in this chapter
and be sure to perform all the basic configuration tasks outlined
above. When you are satisfied that the links are operating
correctly, proceed to mount the units in their intended locations.
Mount the Unit
Using the Pole-Mounting Bracket
Perform the following steps to mount the unit to a 1.5 to 2 inch
diameter steel pole or tube using the mounting bracket:
1. Always attach the bracket to a pole with the open end of the
mounting grooves facing up.
2.
Place the U-shaped part of the bracket around the pole and
tighten the securing nut just enough to hold the bracket to the
pole. (The bracket may need to be rotated around the pole
during the alignment process.)